Reattaching (10cm) front lower skirt

Hello.

Has any one tried to "snap" back into place this piece. Approx 10cm in length in from wheel arch and separated by 3-4 mm. Just on one side.

It is the lowest section of the front. ( not the black rubber spoiler lip )

Seems like a lot of work to remove the complete front bumper / body work to gain access to the clips etc which join these pieces.

I have looked at videos, and might try loosening the 2 bolts under this section to get some wriggle room.

Otherwise some white gaff tape until I have a better reason to dive deeper.

Thanks and have a great Xmas.

Thanks for the feed back.

Very active forum, which is great.

Sorry I don't speak German.

Picture when I can dodge the rain.

Thanks

Follow up for assistance to others.

IMG_1785.jpgIMG_1784.jpgIMG_1786.jpgIMG_1787.jpg

It was quite cold today, so I used some hot water to both clean and soften the panel. ( Plastic )

Removed the panel screw from underneath T20

Pulled back the wheel arch cover slightly to gain better access and see what was going on.

Reseated the tab and attached with white gaff tape. Temporary until I can locate some of the little metal clips.

Difficult to see but in the last phot.

Cheers